The following sections provide configuration information on ONT Ethernet or CATV UNI shutdown. The value range is from 1 to 24.Īctive Example: Device(config-profile-unique-0/1/1)# activeĬonfiguring the ONT Ethernet or CATV UNI Shutdown The options are:ĭuplex_mode: The ONT Ethernet port duplex mode. Speed: The ONT Ethernet port rate mode, in Mbps. Local neg-mode speed speed duplex duplex_mode port port_id Example: Device(config-profile-unique-0/1/1)# local neg-mode speed 10 duplex half port 2 The string length range is from 1 to 128. Modifying and activating the line profile template will cause the ONT that references the template to go online again.Ĭonfigure terminal Example: Device# configure terminalĭeploy profile line Example: Device(config)# deploy profile lineĪim Example: Device(config-profile-unique)# aim 0/1/1 To configure maximum MAC, perform this procedure. Configuring the ONT Ethernet or CATV UNI Shutdown.Configuring the ONT Ethernet UNI Speed and Duplex.Configure ONT Ethernet UNI Bandwidth Egress.The following sections provide additional configuration information on the ONT. Use the show ont-find list interface gpon all command to see the configured vendor ID for the ONTs. If the ONT vendor ID doesn’t match the configured vendor ID, the ONT will not be registered. You can configure a vendor ID for an ONT to limit the number of ONT registrations. Setting an ONT range compensation value reduces the EQD0 reference value error and makes the ONT ranging If the EQD0 reference value is used as the default to measure the physical distance between an ONT and an OLT, inaccurate The EQD0 reference value is different for each ONT ranges. Because of design differences in the ONT chip, The range compensation functionality allows you to reduce ONT ranging errors. The Ethernet or CATV UNI shutdown functionality allows you to shut down an Ethernet port or a CATV port on an ONT. The Ethernet UNI speed and duplex functionality allows you to configure the Ethernet interface rate and duplex mode on an The Layer 2 isolation between the Ethernet interfaces. The local switching functionality allows you to enable local switching on an ONT Ethernet interface. The Ethernet User-Network Interface (UNI) bandwidth egress functionality allows you to configure the egress bandwidth limit Ethernet User-Network Interface (UNI) Bandwidth Egress The maximum MAC functionality allows you to configure the dynamic MAC address learning limit on an ONT interface. Ethernet User-Network Interface (UNI) Bandwidth Egress.The following sections provide information about the additional configurations that can be performed on an ONT. Overview of Additional ONT Configurations Overview of Additional ONT Configurations.
0 Comments
Leave a Reply. |